Instructions For Use; Introduction; Functions - Marmitek LWM1 Guide Utilisateur

INSTRUCTIONS FOR USE - LWM1™
BUILT-IN DIMMER MODULE

INTRODUCTION

Congratulations on the purchase of the Marmitek X-10 built-in
dimmer module LWM1.
• Because of its extremely small proportions, the module can be
built in behind wall switches and wall outlets (minimal
backbox depth 40mm, advice 50mm). The module is also
ideally suited to build in light armatures and for installation in
small spaces in for instance lowered ceilings.
• Multi-purpose: fully free choice in brand, colour and model
switch material. With the built-in dimmer you can switch and
dim 230V light bulbs, 230V halogen lighting and low voltage
halogen lighting with electronic transformer suitable for phase-
ingate up to 120 Watt.
• The module can be controlled by Momentary switches
connected to the module or at a distance, making use of the
Marmitek X-10 (plc) signal through the power line.
• In case of a voltage cut-off, the module will save the reading
prior to the cut-off. (dim level/off).
Please note: due to heat generation, apply no more than
one module per flush socket / central socket!

FUNCTIONS

• Local control via the switch attached to the module or remote
control using Marmitek X-10.
• Built-in dimmer, 120W.
• Two-way X-10: transmits the set dimmer level to other LWM1,
LD11, LW12 and LW11 modules (set to the same HouseCode
and UnitCode).
• Softstart and softdim.
• Memory function for last dimmer setting.
• Responds to ON, OFF, DIM, BRIGHT and extended X-10
(dimmer setting originates from other LWM1 modules).
LWM1 TM 7