Flange-Head Tapping Screw (M4 X 14); Hexagonal Screw (M4 X 15); Velcro Fastener - Alpine IVA-D100 Mode D'emploi

Installing the Power Amplifier
This Power Amplifier is designed for use only with the IVA-D100. If
products other than IVA-D100 are connected to the supplied
Power Amplifier, its specified performance is not guaranteed.
When mounting with Velcro fasteners
When mounting the Power Amplifier with the Velcro fasteners, be sure
to choose a flat location.
Do not hang the unit from the bottom of the dashboard or rear deck with
the Velcro fasteners.
1
Remove the Protective paper and attach two pieces
of Velcro fastener to the bottom of the Power
Amplifier.
Protective paper
2
Check the position, and then fix the Power Amplifier
to the floor carpet.
When mounting with Screws
When mounting the Power Amplifier with the screws, be sure to choose
a flat location.
When making holes, be careful not to scratch any pipes or wires.
1
Install the Power Amplifier on the floor with the
supplied hexagonal screw (M4 × 15).
hexagonal screw (M4 × 15)
(Included)
70
-EN
Power
Amplifier
Protective paper
Velcro Fasteners
(Included)
Power Amplifier
Installing the DC/DC Converter
Install the DC/DC Converter on the floor with the
supplied flange-head tapping screws (M4 × 14).
DC/DC Converter
Flange-head tapping
screws (M4 × 14)
(Included)