Setting The Brightness Of The Backlighting; Adjusting The Minimum Level Of Backlight; Switching Background Textures; Setting Automatic Background Textures - Alpine IVA-D100 Mode D'emploi

Setting the Brightness of the Backlighting

Backlighting is provided by a fluorescent light built into the liquid
crystal panel. The illumination control adjusts the brightness of the
backlighting based on the car ambient lighting for easier viewing.
Setting item: DIMMER
Setting content: OFF / ON / AUTO
OFF: Deactivate Auto Dimmer mode to keep the background
illumination of the monitor bright.
ON: Keep the background illumination of the monitor dark.
AUTO: Adjust the brightness of the background illumination of
the monitor automatically to the brightness of the car
interior.
• When ON or AUTO is set, the setting is also applied for the button
lighting in "Adjusting the Dimmer of Button Lighting at Night"
(page 34).

Adjusting the Minimum Level of Backlight

You can adjust the brightness of the backlight (LOW). This function
could be used, for instance, to change the screen brightness while
travelling at night.
Setting item: DIMMER LOW LEVEL
Setting content: -15 to +15
You can adjust the level between MIN (-15) and MAX (+15).
When it reaches the minimum or maximum point, the display
shows "MIN" or "MAX" respectively.

Switching Background Textures

You have a choice of background textures you can set.
Setting item: BACKGROUND
Setting content: MODE1 / MODE2
• This operation can be carried out after removing the disc from the
unit or when playback of the disc has stopped.
• Wallpapers downloaded from "Downloading the BACKGROUND
data" (page 39) are recalled.
• When you select a source other than the built-in disc on this unit, and
the built-in disc is selected on the rear monitor connected to the unit,
background textures cannot be displayed on the unit.
• When an error message is displayed (ERROR, HI-TEMP, etc.),
background textures selected by this setting cannot be displayed on
the unit.

Setting Automatic Background Textures

The background texture will automatically change each time the
ignition key is turned off and turned back on again.
Setting item: AUTO BACKGROUND
Setting content: OFF / ON
ON: Turn on the Auto Background Texture Scroll mode.
The background textures will scroll when the ignition key
is turned off once and turned back on again as follows:
MODE1 MODE2
OFF: Turn off the Auto Background Texture Scroll mode.
• Wallpapers downloaded from "Downloading the BACKGROUND
data" (page 39) are recalled.

Switching the Font Background Color

You can choose from 5 different colors for the font background.
Setting item: BASE COLOR
Setting contents: MODE 1 to MODE 5
Turning the Touch Panel Vibration ON or
OFF
You can turn the touch panel's vibration ON or OFF during operation.
Setting item: PULSETOUCH
Setting content: OFF / ON
OFF: Turns off vibration during operation.
ON: Turns on vibration during operation.

Adjusting the Touch Panel

Adjustment becomes necessary when the display position on the LCD
and the touch position on the touch panel do not match.
Setting item: SCREEN ALIGNMENT
Setting content: / RESET
1 Touch [ ] of SCREEN ALIGNMENT.
The adjustment screen appears.
2 Accurately touch the
corner of the screen.
The screen changes to the adjustment screen.
3 Accurately touch the
corner of the screen.
This completes adjustment, and returns to the DISPLAY
setup mode screen.
• If you have touched a location other than the
[RESET] to restore the adjustment screen to the initial setting.
• If you touch [RTN] on the adjustment screen, no adjustment is done
and the DISPLAY setup screen is restored.
mark provided in the lower left
mark provided in the upper right
mark, touch
37
-EN