Monitor Setting; Monitor Setting Operation; Adjusting The Monitor Angle; Selecting The Monitor Position - Alpine IVA-D100 Mode D'emploi

Monitor Setting

Monitor Setting Operation

Following Steps 1 to 4 describe the common procedures for
operating the MONITOR setting function. For details of the
setting function items, refer to descriptions of respective items.
1
Press SETUP.
The SETUP selection screen is displayed.
2
Touch [ ] of MONITOR.
The MONITOR screen appears.
3
Touch [ ] or [ ] of the desired item to change its
setting.
Setting items:
TILT / SLIDE / OPEN / CLOSE
4
Touch [RTN] to return to the previous screen.

Adjusting the Monitor Angle

Adjust the monitor's angle (between 40 and 105 degrees) for optimum
visibility.
Setting item: TILT
Setting range: 10 adjustable angles are available.
• If the monitor touches an obstacle, remove the obstacle.
• The screen color will vary when viewed at certain angles. Adjust the
screen angle for the best viewing position.
• If the voltage of the vehicle's battery power is low, the screen may
blink when the screen angle is changed. This is not a malfunction.

Selecting the Monitor Position

The monitor can be set in 2 positions.
Setting item: SLIDE
Setting content: BACK / FRONT
BACK: Slides the display backwards.
FRONT: Slides the display forwards.
• If the monitor is forcibly pushed or pulled, you may not be able to set
the monitor angle or position. In this case, press OPEN for more than
2 seconds to close the monitor once, and then open the monitor
again.
Setting Automatic Opening/Closing of the
Monitor
Setting item: OPEN / CLOSE
Setting content: MANUAL / FULL / CLOSE
MANUAL: The monitor is manually opened or closed by
pressing OPEN.
FULL: The monitor automatically opens and closes when
the ignition key is turned to the "ACC" or "ON/OFF"
position.
CLOSE: The monitor automatically closes when the ignition
key is turned OFF.
28
-EN

Setup

DVD Setup

DVD Setup Operation

To display the DVD mode screen:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the DVD mode operation has been
released. Engaging the parking brake can reactivate the DVD
mode, as long as the car's ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3), of "To
display the DVD mode screen."
Each time the ignition is turned OFF, perform the procedure of "To
display the DVD mode screen."
The DVD Setup operation can be carried out after removing the
disc from the unit.
The following steps 1 to 5 are common operations to each
"Setting item" of DVD Setup. Refer to each section for details.
1
Press SETUP.
The SETUP selection screen is displayed.
2
Touch [ ] of OTHER SETUP.
The OTHER SETUP screen appears.
3
Touch [ ] of DVD SETUP.
The DVD setup screen appears.
4
Touch [ ] or [ ], etc., of the desired item to change
its setting.
Setting items:
MENU LANGUAGE / AUDIO LANGUAGE / SUBT. LANGUAGE /
COUNTRY CODE / PARENTAL / DIGITAL OUT /
DOWNMIX MODE / TV SCREEN / BONUS CODE /
DVD-A SETUP / PBC