Installation; Screw (M4 X 8) - Alpine IVA-D100 Mode D'emploi

Installation

Installing the Monitor
Installation Location
Before deciding on the mounting location, check that opening and
closing the display will not hamper gear shifting in that position.
• Install at an angle of within 30 degrees from the horizontal.
• The monitor's angle is set to 90 degrees at the factory. Depending on
the car, the monitor may hit the dashboard when opened. The
monitor's angle can be adjusted and stored in memory so that the
monitor will not hit the dashboard when opening. For adjusting the
monitor, refer to "Adjusting the Monitor Angle" on page 28.
Even when the vehicle's battery power is removed, the adjusted
monitor angle remains stored in memory.
1
Dashboard
Mounting Sleeve
(Included)
Flush head Screws
(M4 × 3) (Included)
Slide the mounting sleeve into the dashboard. Install the
supplied bracket on the monitor.
• Make sure to use the supplied Flush head screw (M4 × 3) to
install the monitor.
If you use another screw to install the monitor, it may cause a
malfunction.
2
Hex Nut (M5)
Meatal Mounting
Strap
Ground
Lead
Chassis
Reinforce the monitor unit with a metal mounting strap (not
supplied). Secure the ground lead of the unit to a clean
metal spot using a screw (
vehicle's chassis.
• For the screw marked
chosen mounting location.
Mounting Bracket
(Included)
IVA-D100
Screw
Bolt Stud
IVA-D100
Front Frame
(Included)
Wider edge should face down.
) already attached to the
, use an appropriate screw for the
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming from the
left rear of the IVA-D100. Connect all other leads of the IVA-
D100 according to details described in the Connections
section.
3
Lock Pin
Slide the IVA-D100 into the dashboard. When the unit is in
place, make sure the locking pins are fully seated in the
down position. This can be done by pressing firmly in on the
unit while pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly locked
and will not accidentally come out from the dashboard.
Install the supplied Front Frame.
Removal
1. Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see Step 3). As each
pin is unlocked, gently pull out on the unit to make sure
it does not re-lock before unlocking the second pin.
2. Pull the unit out, keeping it unlocked as you do so.
< JAPANESE CAR >
To install using the vehicle's standard bracket.
Ground Lead
IVA-D100
• Make sure to use the supplied flush head screw (M4 × 3) to install the
monitor.
If you use another screw to install the monitor, it may cause a
malfunction. However, only if you cannot install with the flush head
screws (M4 × 3), use the supplied screw (M4 × 6).
Flush Head Screws (M4 × 3)
(Included)
Mounting Bracket
69
-EN