Using The Product - TESTO 510 Mode D'emploi

3 Press (
4 Repeat steps 2 and 3 for all functions.
- The instrument changes to measuring mode.

Using the product

For velocity to be measured, the unit of density and density
value must be set correctly, see chapter 'First steps', section
'Basic settings (configuration mode)'.
Switching t t he i i nstrument o o n:
Press .
- Measuring mode is opened.
Switching t t he d d isplay l l ight o o n:
The instrument is switched on.
Press .
- The display light goes out automatically if no key is
pressed for 10 seconds.
Zeroing t t he m m easuring i i nstrument:
The instrument can only be zeroed in the range up to
10 hPa.
Press .
- Zeroing takes place.
Changing t t he d d isplay v v iew:
Adjustable views
· Current reading
· Hold: Readings are held.
· Max: Maximum values since the instrument was last switched on or last reset.
· Min: Minimum values since the instrument was last switched on or last reset.
· Hold Avg: Timed mean value calculation, see below.
Press several times until the desired view appears.
) to confirm the input.
Using the product 15