Open Rings; Gas Oven; Instructions For Use; Lighting And Adjusting The Open Rings And The All Plate - Lotus TP-98G Instructions Pour L'installation Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Open rings:

The cocks can be changed by removing the front panel; to change the thermocouples and burners you have to remove

Gas oven

the gas-cock, timer, thermocouples, burners and ignition plugs can be changed by accessing them inside the oven and/or
by removing the bottom oven panel or control panel.
Attention! The appliance must only be used under surveillance.

LIGHTING AND ADJUSTING THE OPEN RINGS AND THE ALL PLATE

On the front panel, above each knob, the burner it corresponds to is indicated by the index
Use a lighter to light the gas: turn the knob to the left, from the "0" position to the
(see figure), hold it down and light the gas.
Keep the knob pressed a few second and then let it go, this lights the pilot.
If the flame goes out you have to repeat the procedure.
By turning the knob round to the
By turning the knob round to the
To switch off, move the knob back into position " 0".
To light, turn the knob to the left from position "0" to the
keep it pushed down and press the button with the
It is possible to check the flame through the inspection hole on the oven floor (bottom); after a
few seconds, release the knob. If the flame goes out, repeat the operation. Turn the knob into
the position of the desired temperature.
To turn off the oven, turn the knob to the right, into position "0"
Attention! - When the oven is on, the door must not remain open because it could heat and
damage the knobs.
NB: Cookers with a gas oven are provided with an acoustic timing device, able to signal a
maximum time of 120 minutes. Turn the knob to the right, positioning on the time desired,
between and including 0 to 120 minutes (see figure); at the end of the set time, the alarm goes
off.
Turn the control knob to the right and set the temperature wanted.
To turn the oven off, turn the knob to the left to position 0.
To turn the oven on, turn the selector knob (see figure) to the right or left into one of the
following positions
Caution: when the oven is on the door must be kept shut otherwise the knobs and protection
sheet could get hot and be damaged.
GB
the rungs and trays.

INSTRUCTIONS FOR USE

LIGHTING AND REGULATING GAS OVEN BURNER

TURNING ON AND ADJUSTING THE STATIC OVEN

Top + bottom heating element
Bottom heating element
Top heating element
IE
IT
CH
position the burner is at maximum
position the burner is at minimum.
symbol until the gas lights.
47
sign
symbol (see figure);

Publicité

Table des Matières
loading

Table des Matières