Specifications; Serial Number Plate - SciCan HYDRIM M2 G4 Mode D'emploi

11. Specifications

Applicable Standards
Height (Full height unit)
Height (Short height unit)
Width
Depth (Door closed)
Depth (Door open)
Weight
Required clearance, top, sides and rear
Maximum Running Noise
Inlet water connections
Inlet water pressure
Drain
Maximum water flow to drain
Maximum water discharge temperature to drain
Maximum water hardness
Maximum water conductivity
PH range
Water softener salt capacity
Equipment installation category
Voltage
Frequency
Rated load
Circuit breaker
Operating temperature range
Maximum relative humidity
Maximum operating altitude
Equipment pollution degree
Maximum deviation from plane horizontal surface
Detergent requirements:
Detergent consumption per cycle
Consumption and processing temperatures

12. Serial Number Plate

When ordering supplies, spare parts or requesting service, please ensure that the
information contained on the serial number plate is available (Model number, serial
number etc.).
The serial number plate is located at the bottom left on the rear panel of the HYDRIM M2
G4 unit. A small label is located on the left hand side of the chemical door.
EN ISO 15883 parts 1 & 2
850 mm
820 mm
598 mm
600 mm
1200 mm
90 kg
>10 mm
< 78 dB(A)
G 3/4"
2-5 bar
3/4"
47 l/min
95°C
30.3dH, 31.6 US GPG, 540 PPM
844 µS/cm
>6.8 and < 8.5
1.0 kg
II
230 – 240 vAC +/- 10%
50 Hz or 60 Hz, * see serial number label for
requirements specific to your unit.
2.5 kW
13 amps
+5°C to +40°C
80% for temp up to 31°C
50% for temp up to 40°C
2000 m
2
2 mm
Single solution – Scican HIP chemical only.
Not supplied with machine.
108 ml
wash: 1.2% @ 70°C
rinse: 0.15% @ 60-94°C
42