Hints And Tips - SciCan HYDRIM M2 G4 Mode D'emploi

5. Instructions for Use (cont.)
5.2 Hints and tips to get best results from your HYDRIM M2 G4:
• Remove all cement, composite material and amalgam from instruments chairside prior
to processing in the HYDRIM.
• Use only accessories, such as baskets, cassettes, trolleys and racks to hold
instruments that are designed for the HYDRIM M2 G4.
• Use accessories for their intended purpose only. For example, do not place hinged
instruments in cassettes but use the hinged instrument rack instead.
• Disassemble instruments if possible.
• Avoid overlapping instruments. Each instrument must be kept separately.
• All instruments must be placed in the instrument washer-disinfector in such a way
to allow good rinsing of all surfaces. Any surface that is shielded from water and
detergent cannot be cleaned.
• Open hinged instruments widely when placed in baskets or hinged instrument rack
(PN 01-110409S). Closed hinged instruments cannot be cleaned.
• Place hollow lumens (suction tubes) and other hollow instruments in the rack for
vertical instruments (PN 01-01-110411S). Do not place hollow lumens (suction tubes) or
hollow instruments horizontally on a basket or in a cassette and ensure that water can
flow unrestricted in and out of the instrument.
• Place trays and other concave shaped items at an angle to ensure water can run off
surfaces easily.
• Do not overload the HYDRIM machine.
• Verify the HYDRIM Machine setup
– Ensure that the washer spray arms are free of any blockage.
– Ensure that the mesh filters in the chamber drain are free from debris.
• For achieving best cleaning results, instruments should be processed in the HYDRIM
as soon as possible. If immediate cleaning is not possible, it is recommended to
process the instruments using the P1 Rinse and Hold program immediately after use
on the patient.
• Inspect visually instruments for cleanliness and integrity (corrosion, material changes)
after cleaning and repair or replace instruments if necessary
11