Tv Anywhere Receiver; Control Elements Receiver - Marmitek 20095 Guide Utilisateur

original remote or the remote control supplied from the location of the TV Anywhere
Receiver (e.g. at your remote TV). The antenna must be placed in an upward position.
2. Output jack: for the infrared extender LED's. (Please read paragraph 4.2 for more
information.)
3. Antenna input (Cable In): To connect the TV Anywhere transmitter to the Antenna wall
output (cable signal). Use the antenna cable provided.
4. Audio/Video input: Input for audio and video signals from your DVD player, VCR, etc.
5. Audio/Video output: Signal available at the output is either the antenna signal
transmitted (if transmitter is in "Cable" mode) or the signal connected to the
Audio/Video input [4]. (Mode selected on the remote control: "CATV/AV".)
6. Power input: The supplied mains adapter (large) is connected to this input jack.
7. Power ON/OFF: This is for switching the transmitter on and off. When switched on the
LED [13] will light up.
8. 2.4 GHz antenna: Transmits the audio/video signals to the receiver.
9. Channel selector: To set the 2.4GHz channel. The settings for the transmitter and receiver
should be same (A,B,C or D).
10. Source: To switch between antenna input [3] and external connected equipment [4].
11. Cable Channel Down: Channel selection of the TV channels programmed.
12. Cable Channel Up: Channel selection of the TV channels programmed.
13. LED indicator: lights up when the unit is switched on [7].

3. TV Anywhere receiver

To operate the receiver, please use following items supplied:
• TV Anywhere receiver
• Power supply 9V (small)
• RCA/RCA cable
• Scart adapter indicated "Receiver"

3.1 Control Elements Receiver

1. 433MHz antenna: Transmits the RF signals from the IR extender in the TV Anywhere
receiver. This allows you to operate your equipment (VCR, DVD player, etc.) with your
original remote control or the remote control supplied from the location of TV Anywhere
receiver (e.g. at your remote TV). The antenna must be placed in an upward position.
2. A/V Output: Connect this output to your remote TV (or VCR) by means of the RCA cable
and the Scart adapter supplied.
3. Channel Selector: To set the 2.4GHz channel. The settings for the transmitter and receiver
should be same (A,B,C or D).
4. Power input: The 9V mains adapter supplied is connected to this input jack.
5. Power switch: This is for switching the receiver on and off. When switched on, a red
indicator lights up.
6. 2.4 GHz antenna. Receives the audio/video signals from the transmitter.
7. IR Window: Point your remote at this window to transmit IR commands to the equipment
connected to your TV Anywhere receiver.
TV ANYWHERE
5