Manual Code Search; Identifying Codes Found - Marmitek 20095 Guide Utilisateur

4. Press Prog+ [5] once. After a few seconds the remote control will start stepping through
the code library (fast search, 1 code per second). When the device responds, you can
press Prog+ [5] to switch to slow search (1 code per 3 seconds). You can step back by
pressing Prog- [5] (you can step forward by pressing Prog+ [5] in case you went back too
far). As soon as the device responds again, press ENT [11] to store the code you found.
☺
if some functions of your device do not work, you need to try another code for your
brand. The search function starts after the last confirmed code. For example, if it was 030,
the search function starts at 031, and it will keep on trying until the last possible code.

7.3.4. Manual code search

Note: You can dedicate any device (TV, DVD, SAT...) to the VCR, CBL, DVD, CD, ASAT, DSAT
or AUX buttons. You first need to enter a 3-digit code for the type of device you wish to
control (from the code book), i.e. if you want to program a SAT under the AUX button, enter
ANY SAT code from the code book and then follow the steps below:
1. Make sure your device is switched on.
2. Press and hold SETUP [7] until the LED indicator stays lit. Release SETUP.
3. Press the mode button [3] that matches the device you want to control (for example TV).
4. Press Prog+ [5] repeatedly until the channel changes. If you step past the correct code,
use Prog- [5] to go back to the right code.
5. When the device you want to control reacts, press ENT [11] to confirm the code.
☺
If your equipment does not have Prog+, you can use PLAY (VCR or DVD) [19] or POWER
[1]. The search starts after the last registered code. If that was 030, the search starts at
031 until the last possible code and then goes from 000 to 029. Note: if certain functions
of your equipment cannot be controlled, you will have to find a different code for your
brand.

7.4 Identifying codes found

If the batteries have been outside the remote control for a longer period, the programmed
codes may be erased from the memory. It is a good idea to write down the codes, so you can
reprogram the remote control quickly. If you don't know the code (for example because you
found the code by autosearch), you can identify it as follows:
1. Press and hold SETUP [7] until the LED indicator [2] stays lit. Release SETUP.
2. Press the mode button [3] for the device you want to identify (VCR, DVD, ASAT or DSAT).
The LED will flash once.
3. Press SETUP again. The LED will flash once. To identify the first digit, press each number
button from 0-9 [9] until the LED flashes. The number you pressed, is the first digit of the
code.
5. Press each number key from 0-9 as above to find the second digit.
6. Press each number key from 0-9 as above to find the third digit. When the third digit has
been found, the LED will extinguish.
16 MARMITEK