Resetting The Configuration Of The Remote Control - Marmitek 20095 Guide Utilisateur

5. Press the SOURCE and CHAN UP buttons (right button) at the front of the transmitter at
the same time.
6. The following text will appear on your screen:
HANDSET CODE 636
PRESS [SET] TO CHANGE
OR
ANY OTHER KEY TO CONTINUE
7. Press "SET". The following text will appear on your screen:
PRESS [SET] AGAIN TO
CONFIRM
8. Press "SET" again.
9. The following text will appear on your screen (where XYZ is the new code):
CODE XYZ ACCEPTED
10. Test the connection by pressing PROG+ or PROG-.

7.8 Resetting the configuration of the remote control

You can reset the remote control to its original configuration, as follows:
1. Press the SETUP button until the LED stays lit.
2. Press the STOP button twice and then press the MUTE button once.
3. The LED will extinguish.
18 MARMITEK