Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PP
4.2.2 Liner (plastic)
For use with aluminium, copper, nickel and stainless steels
1
10
9
8
1
Wire conduit
2
Central connector
3
Nut
4
Wire feed rolls
Fig. 3
Shortening the PA liner
1 Lay down the cable assembly straight and unscrew nut from central connector (2).
2 Sharpen the beginning of the PA liner (8) to approx. 40° using the ABICOR BINZEL
sharpener (9).
3 Slide PA liner (8) through the wire conduit (1) into the inlet nipple (10) until a noticeable
resistance is felt.
4 Slide clamp nipple (7), O-ring (6) and nut (3) on the PA liner (8) and tighten the nut (3)
under tension.
5 Mark a PA liner (8) that is too long in front of the wire feed rolls (4) (wire feeder).
6 Cut the PA liner (8) at the mark directly in front of the wire feed rolls using the
ABICOR BINZEL cutter (5) .
7 Sharpen the cutting point.
4.3 Connecting the cable assembly
WARNING
Risk of burns
The welding torches will become overheated if the coolant level is too low.
• Wear protective gloves.
• Check the coolant level at regular intervals.
1 Join central connector and central socket at the wire feed unit and secure them with the
connection nut.
2 Properly mount the connections for coolant supply/return, shielding gas and control lead
plug.
BAL.0212.0 • 2018-07-16
2
40°
7
6
5 ABICOR BINZEL Cutter
6
O-ring
7
Clamp nipple
4 Putting into operation
3
4
5
8
Liner (plastic)
9 ABICOR BINZEL
Sharpener
10 Inlet nipple
EN - 9
Publicité
Table des Matières
