Risk Of Burns; Welding Process; Putting Out Of Operation - Abicor Binzel ALPHA FLUX 350 Mode D'emploi

ALPHA FLUX

7.1 Welding process

8 Putting out of operation

DANGER
Shortness of breath and poisoning caused by inhaling
phosgene gas
During the welding of workpieces that have been degreased with chlorine-
containing solvents phosgene gas is formed.
• Do not inhale smoke and vapours; prepare sufficient fresh air.
• Clean the workpieces before welding with clean water; do not place any
degreasing baths containing chlorine in the vicinity of the welding area.
• Use the respiratory protection.
• Observe the TLV values.
DANGER

Risk of burns

During welding sparks, glowing work-pieces or hot slag can produce
flames.
• Check work area for fire.
• Make suitable fire extinguishing materials available at the workplace.
• Allow work-pieces to cool down after welding.
• Prior to performing welding work, fasten the ground clamp properly to
the work-piece or the welding table.
WARNING
Arc eye
The arc produced by welding may damage the eyes.
• Wear protective clothing and eye protection.
1 Start the welding process.
1 Switch off the power supply.
8 Putting out of operation
EN - 11