Nussbaum WA 780 Manuel D'instructions page 93

IMPORTANT: Do not touch the measuring
sensors during the measurement data
acquisition phase.
4. Manually turn the wheel 90° following the
instructions (fig. 25).
IMPORTANT: Turn clockwise only.
5. Press the relative "ROC" key for the meas-
uring sensor to make the sensor store the
position.
6. Wait for the audible signal and for the "OK"
message to appear, indicating that the "90°"
position has been saved in the memory.
7. Manually turn the wheel by another 90°
in the same direction.
IMPORTANT: Turn clockwise only.
8. Press the relative "ROC" key for the meas-
uring sensor to make the sensor store the
position.
9. Wait for the beeper and for the "OK" mes-
sage to be displayed, indicating that the
"180°" position has been stored in memory.
10. Repeat steps 3, 4, 5, 6, 7, 8, 9 for the
other wheels.
Remarks
• Turn the wheel clockwise only.
• The compensation of a wheel can be re-
peated by pressing the "ROC" key of the
corresponding measuring sensor.
• Compensation may be carried out simul-
taneously on multiple wheels, but must
not be carried out simultaneously on two
wheels on the same side of the vehicle
(e.g. front right wheel and rear right wheel).
User Manual WA 780 - Cura S 780
"PUSH MODE ROC" EXECUTION
• Make sure the wheels rotate freely and
the measuring sensors are blocked.
• The procedure starts automatically. Four
hourglasses are displayed on the screen
indicate the beginning of the measure-
ment; when the hourglasses disappear
and the "OK" message appears on the
four wheels, the initial position (0°) of all
four wheels has been stored.
• Push the vehicle following the instruc-
tions (fig. 26) so as to turn the wheels by
approximately 90°.
25
• Press the "ROC" key of any of the meas-
urement sensors to make the sensors
store the position. Wait until the "OK"
messages are displayed, indicating that
the positions for all wheels have been
stored.
• Return the vehicle to the initial position
turning the wheels by approximately 90°
in the opposite direction.
• Press the "ROC" key of any of the meas-
urement sensors to make the sensors
store the position. • Wait until the "OK"
messages are displayed, indicating that
the positions for all wheels have been
stored.
At the end of the compensation proce-
dure, a screen is displayed, with icons in-
dicating the operations to be performed
next:
- Lower the vehicle (only for "3-point
ROC")
- Adjust the suspensions shacking the ve-
26
GB
93