Nussbaum WA 780 Manuel D'instructions page 106

Message
"Operation successful"
"Operation failed"
"Not enough disc space"
"Data filing path not found"
"Undefined error."
The "Save Data" procedure can be performed in manual or automatic mode.
The "Save Data" procedure can be carried out in compressed mode (zip format) or by
simply making an exact copy of the files, without zipping them.
For the automatic mode, the following functions can also be set:
1. how often the programme should perform the "Save Data" procedure
2. confirmation request to the user before filing.
To set the "Save Data" procedure, proceed as follows:
1. From the starting screen (Logo screen), open the drop-down menu, pressing "F11".
2. Select "Setup" with the ↑ or ↓ arrows.
106
Description
Operation carried out successfully (Settings
saving, "Save data" execution, "Reset data"
execution).
Operation carried out unsuccessfully (Settings
saving, "Save data" execution, "Reset data" ex-
ecution). Try carrying out the operation again.
During the "Save data" procedure, the space
available, in the destination path selected, is
less than what is requested. The procedure
is not performed. Select another path with
enough space and repeat the procedure.
During the "Save data" procedure, if you
try to perform the "Save data" procedure in
a path not found (wrong) or removed (E.g.
USB support).
Check by performing the procedure described
in the paragraph
- "Save Data" procedure setting section - the
path set for the "Save data" procedure and,
if required, select a valid path.
In presence of an unpredicted status. Indicate
the exact procedure performed, which has
caused the error, to the technical support
service.
"Save Data" procedure (Backup)
"Save Data" procedure setting
User Manual WA 780 - Cura S 780