Jack & Hold Programme; Toe Curve Window - Nussbaum WA 780 Manuel D'instructions

JACK & HOLD
PROGRAMME
This programme is started by selecting
"Regolazione vettura sollevata" ("Adjustment
with car lifted") from the F11
It allows the vehicle characteristic angles
to be adjusted with the axle concerned
lifted, by first locking ("freezing") the value
displayed for the lowered vehicle, so that
the variation caused by the lifting opera-
tion is ignored.
Proceed as follows:
- with the vehicle lowered, select "Regolazi-
one vettura sollevata" ("Adjustment with car
lifted") from the F11 menu
to fix (freeze) the values;
- level the measuring sensors;
- lift the vehicle;
- check the measuring sensors and level
them, if required;
- press F3 to confirm vehicle lifting;
- perform the adjustment;
- select from the F11 menu
the "Fine Regolazione vettura sollevata" ("End
of adjustment with car lifted") option to lock
(freeze) the values again;
- lower the vehicle;
- check the measuring sensors and level
them, if required;
- press F3
lowering.
100
menu.
menu
again to confirm vehicle

TOE CURVE WINDOW

The window (available for the versions that
support it) can be called up from the front
axle adjustment window only, by pressing
the F11 key, selecting the "Curva di Conver-
genza" ("Toe Curve") option from the list and
pressing Enter.
It allows the manual toe curve measurement
and adjustment procedure to be performed.
The preparing vehicles for wheel alignment
window is displayed. Follow the instructions
indicated and press F3.
The toe curve adjustment window is dis-
played; adjust, then press F3.
The preparing vehicles for wheel alignment
window is displayed again. Follow the instruc-
tions indicated and press F3 to go back to
the front axle adjustment procedure.
During toe curve execution, the following
keys are active:
F1 displays the on-line "Help"
function
F2 goes back to the previous
screen
F3 (or Enter) goes to the next
screen
F11 displays the menu with the
relative functions.
These are the menu options:
• Start context (goes back to the starting
screen)
• Vehicle adjustments (opens the screen for
selecting/displayingtheadjustmentimages
of the vehicle angles)
• Help (recalls the Help screen relative to the
current screen).
User Manual WA 780 - Cura S 780