Recommended Fire Extinguishing Equipment; Glossary - Nussbaum WA 780 Manuel D'instructions

teries (only if contained in the product).
With your help, we can reduce the amount of
natural resources used to produce electrical
and electronic equipment, minimise the
use of landfills to dispose of old products,
and improve quality of life by preventing
the discharge of potentially hazardous
substances into the environment.
RECOMMENDED
FIRE EXTINGUISHING
EQUIPMENT
When choosing the most suitable fire extin-
guisher consult the following table:
Dry
materials
Water YES NO
Foam YES YES
Powder YES*
YES
CO YES YES*
2
YES* = Use only if more appropriate ex-
tinguishers are not at hand and when the
fire is small.
WARNING
The indications in this table are of a
general nature.They are designed as a
guideline for the user.
The applications of each type of extin-
guisher will be illustrated fully by the
respective manufacturers on request.
User Manual WA 780 - Cura S 780
Flammable Electrical
liquids Equip-
ment
NO
NO
YES
YES*

GLOSSARY

Find below a brief description of some of
the technical terms used in this manual.
Characteristic Angles
This term refers to all the angles that can
be normally measured on an aligner (total
front/rear toe, left/right and front/rear half
toe values, left/right and front/rear camber,
left/right caster, left/right king pin angle,
and steering angle difference at 20°).
CMOS
Special type of infrared sensor. It has ex-
cellent linearity.
Longitudinal goniometer
CMOS sensor that measures the angles
using an infrared beam that is parallel to
the vehicle's axis of symmetry. goniometers
that measure the angles between the front
and rear part of the vehicle.
Transverse goniometer
CMOS sensor that measures the angles
using an infrared beam that cuts across
the vehicle. goniometers that measure the
angles between the right and left side of
the vehicle.
Clamp
Adapter from wheel and measuring sensor.
GB
40
115