Operation Of The Flashing Light - Abus Secvest FUSG50101 Instructions D'installation Et D'utilisation

Note:
Flashing or non-flashing of the comfort LEDs during normal operation.
Connect the batteries with the cover open.
The software version will be displayed, as described above.
The sounder switches to the silent start-up phase. Both comfort LEDs light up red.
Press the tamper switch very quickly five times in a row. This will turn the flashing on or off.
Note:
Each time the tamper switch is pressed, there is a time out of 500 ms.
This means that in order to switch the comfort LED display, the switch must in each case be
pressed within this time window.
If the housing is opened and closed many times (more than 5 times), the pressing of the tamper
switch is outside of the 500 ms time frame and therefore no accidental switching takes place.
Their current status is displayed as shown here:
BOTH LEDs on:
ONE LED (right LED) on: Comfort LEDs do not flash in normal operation
The installer mode display and the software display will not be affected by this.
Note:
for software <= 1.8 or for FUSG50100
The read-in signal is sent after the version number is displayed.
The tamper switch triggers no further transmissions. Only after the silent start-up phase has been
stopped by closing the cover for at least 10 seconds will both of the red LEDs no longer light up.

Operation of the flashing light

The flashing light is activated if the sounder activates itself or the alarm panel sends a command to
activate the flashing light.
Fifteen minutes after the sounder is activated, the flashing light flashes more slowly, until the alarm
is reset.
With Secvest systems, the options "Strobe on Set" and "Strobe on Unset" can be set in the alarm
panel configuration (see Set Conf description)
Comfort LEDs flash in normal operation
Functions, jumpers and displays
49 | EN