Environmental Concerns - Zanussi ZRT724W Notice D'utilisation

6. Unscrew the bottom far
side screw and install on
the opposite side.
10. On the opposite site,
install the hole covers pro-
vided within the accessory
bag.
1) If foreseen
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that case,
wait for the natural fitting of the gasket.
In case you do not want to carry out the above men-
tioned operations, contact the nearest After Sales Serv-
ice Force. The After Sales Service specialist will carry
out the reversibility of the doors at your cost.
Electrical connection
Before plugging in, ensure that the voltage and frequen-
cy shown on the rating plate correspond to your domes-
tic power supply.

Environmental concerns

The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
32
7. Unscrew the top door
holding pin.
11. Tighten the hinge.
Make sure that the doors
are aligned.
8. Screw the pin back on
the other side.
12. Remove and install the
1)
handle
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the
domestic power supply socket is not earthed, connect
the appliance to a separate earth in compliance with cur-
rent regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
appropriate collection point for the recycling of
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
2
3
1
9. Fit the doors into the
pins and install the doors.
Install the hinge.
13. Reposition, level the
appliance, wait for at least
four hours and then con-
nect it to the power socket.