SOLIS Espresso Master 113 Mode D'emploi page 69

Problem
Machine is making pulsing/
pumping sound while
extracting coffee or
steaming milk
No steam/hot water is
generated
Milk is not foamy
after frothing
Machine not working
Anleitung_Espresso_Master_2.indd 69
POSSIBLE CAUSES
The machine is carrying out the normal operation of the
15 bar pump
Machine is not turned on
Water tank is empty
Selector Control not in 'Steam or Hot Water' position
Steam Wand is blocked
Not enough steam
Milk is not fresh and cold
The unit appears to be 'on' but the machine ceases to operate.
What to do
No action required as this is the normal operation of the machine
Ensure the machine is plugged in and the 'on/off' button is in the
'on' position.
Refer to step 1 – Filling the water tank on page 56.
Turn the selector control to the 'Steam' position. Ensure the steam button
is selected for steam and 'Hot Water' button selected for hot water.
Use the pin on the cleaning tool to clear the opening. If the steam
wand continues to be blocked, remove the tip of the steam wand
using the spanner in the middle of the cleaning tool. Please refer to
'Care and cleaning' on page 64.
Steam wand may be blocked. Please refer to 'Care and cleaning'
on page 64.
Milk must be cold and fresh. Please refer to 'How to froth milk for
a cappuccino or latté' on page 60.
The safety thermal cut-out may have activated due to the pump
overheating. Turn the machine off and allow it cool for about
30–60 minutes.
E
69
2.12.2009 16:07:01 Uhr