SOLIS Espresso Master 113 Mode D'emploi page 58

STEP 6 – inserting the filter holder
• Place the filter holder underneath the group
head so that the handle is aligned with the
insert graphic. Insert the filter holder up into
the group head and rotate the handle to the
E
right until resistance is felt, this will be at an
approximate 90° angle to the machine.
STEP 7 – brewing the coffee
• Ensure all the button surrounds on the control
panel are illuminated, indicating the machine
has reached the correct temperature for brewing,
and is ready for use.
58
Anleitung_Espresso_Master_2.indd 58
• Ensure the drip tray and filter holder are in
place.
• Place one or two pre-warmed cups beneath
the filter holder outlet.
Programmed Espreso – ONE Cup
Press the one cup button once. After a few seconds,
aromatic coffee will begin to pour into the cup.
A pumping noise will be heard in this operation.
The machine will automatically stop once the preset
pour has been delivered.
Programmed Espreso – DOUBLE Cup
Press the two cup button once.
After a few seconds, aromatic coffee will begin to
brew into the cup. A pumping noise will be heard in
this operation. The machine will automatically stop
once the preset pour has been delivered.
NOTE: The minimum pour for one cup and two
cups is set at 15ml.
NOTE: Pressing the one cup or two cup buttons
during a programmed espresso will immediately
stop the pour.
Programming Single Espreso
1. Prepare to make a single cup of espresso by fol-
lowing steps 2 to 6 in 'Operating your Espresso
Machine', pages 56-58.
2. Place your cup underneath the group head.
3. To begin programming, press the 'PROGRAM'
button once. The machine will beep once and the
program button will begin to flash. This indicates
the machine is in programming mode.
4. Press the one cup button once. The machine will
commence normal pour function, and the one
cup button surround will begin to flash.
5. When the desired amount of espresso has
poured into the cup, press the one cup button to
stop the pour.
The machine will beep twice, indicating it has
saved your measured pour quantity and exited
rogramming mode.
2.12.2009 16:06:58 Uhr