Wilo Stratos Notice De Montage Et De Mise En Service page 19

Double pump mode (as two single pump mode): Setting when starting up for
the first time
(vertical display)
LC display
Installation and operating instructions Wilo-Stratos
Setting
When the module is switched on all symbols
appear in the display for 2 seconds. Menu
appears.
The symbol MA = Master blinks on the display of
both pumps.
Should the settings not be altered, both pumps will
run at a constant speed (H
Q = 0).
By on the master pump tuning button the
setting mode menu
SL = Slave appears automatically on the slave
pump display.
The configuration: left pump Master, right pump
Slave is thus selected. The tuning button on the
slave pump is deactivated. No more settings can be
made here.
A position setting for the display cannot be made
on the slave pump. Position setting on the slave
pump is taken over from the settings of the master
pump.
= ½ H where
S max.
appears on the display.
English
then
19