Wilo Stratos Notice De Montage Et De Mise En Service page 15

English
Operating the tuning button: (fig. 1, pos. 1.3) Starting from the basic setting,
the setting menus are selected one after the other in a fixed order by pressing
the button (in 1st menu: press for more than 1 second). The relevant symbol
blinks. By turning the button to the left or to the right the parameters on the
display can be altered up or down. The symbol which has just been set blinks.
The new setting is stored by pressing the button. At the same time the system
advances to the next setting option.
The set value (differential pressure or speed) in the basic setting can be altered
by turning the tuning button. The new value blinks. The new setting is stored by
pressing the button.
If the new setting is not confirmed, after 30 seconds the old value is restored
and the display returns to the basic setting.
Settings of the display position: For the layout of the control module, whether
installed horizontally or vertically, the position of the display can be rotated
through 90°. The position setting can be entered in menu point 3. The display
position specified by the basic setting flashes by "ON" (for horizontal position).
The display can be rotated by turning the selector button. "ON" flashes for the
vertical position. The setting is confirmed by pressing the selector button.
Display position:
Position setting
in menu point 3
Installation and operating instructions Wilo-Stratos 15