Wilo Stratos Notice De Montage Et De Mise En Service page 16

English
The following menus appear in succession on the pump display:
(horizontal representation of display)
Single pump mode: Setting when first used / Menu order during standard use
LC display
If no setting is made in the subsequent menus for 30s,
the basic setting
16
Setting
After switching on the module, all symbols appear
on the display for 2 seconds. The current setting
then engages.
Current (basic) setting (factory default):
auto
e.g. H 18.0 ft
re-appears in the display.
Subject to technical alterations!
• automatic night setback
enabled,
Pump runs in standard mode
• present differential pressure
setpoint H
S
time ½ H
max
s
depending on pump type)
• Control system Δp-v
The differential pressure set point can
be altered by turning the tuning button.
The new differential pressure set point
blinks.
The new setting is stored by pressing
the button briefly.
If no button is pressed, the previously
set blinking differential pressure set
point returns to the previous value after
30 seconds.
Press tuning button for > 1 second.
The next menu point
= 18.0 ft at same
(factory setting
appears.
WILO AG 05/2007