Changing The Transmitter Mode - Walkera Ikarus HM 5 4B HM Manuel D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

For example:

First remove the transmitter crystal and the battery box.

Unscrew the back of the transmitter.

Look at Pict. 1 and unhook the spring on the left gimbal stick unit.

For easier removal of the neutralizing lever (Pict. 2) loosen the four screws of the left gimbal

stick unit a little.

Remove the neutralizing lever and tighten the four screws again.

Remove ratched from right unit (viewed as shown in above Pict. 1). Install the neutralizing le-

ver (shown in Pict. 5) as well as the spring on the right unit. This gimbal stick is now self neu-

tralizing.

Install the ratchet on the left unit at the location shown in Picture 1.

Next swap the leads of the two gimbal stick units. Left inner lead onto right inner connector,

left outer lead onto right outer connetor and visa versa. (see chapter „The Different Modes")

Be careful when pulling the connector off the circuit board in the transmitter rear cover so that

no leads get pulled out of the connectors. Always pull on the connector housing, NOT on the

leads.

Screw transmitter rear cover back on.

Change the setting of the reverse switches (DIP Switches) 1 and 2 on the back of the trans-

mitter (Pict. 3) to correct the directional operation of the servos. Deﬁnitely check before your

ﬁrst ﬂight, that the servo direction is actually correct.

Pict. 1

Install

ratchet

Remove

neutralizing

lever

Remove

spring

Servo reverser switch:

You can reverse the servo operation direction with the

help of the switches on the back of the transmitter. This

has the advantage that you do not have to pay attention

to the servo direction during installation into the model.

The servo reverse switches are assigned as following

(switches 5 – 8 are inherent):