Walkera Ikarus HM 5 4B HM Manuel D'utilisation page 28

- When charging a 2-cell (7.4V) Li-Ion or Li-Po battery, plug the special battery connector into
the charge jack for 2-cell (7.4V) batteries. The Charge LED will flash red indicating that the
battery charger is in charge mode. As soon as the battery is fully charged the LED will turn
green.
- When charging a 3-cell (11.1V) Li-Ion or Li-Po battery, plug the special battery connector into
the charge jack for 3-cell (11.1V) batteries. The Charge LED will flash red indicating that the
battery charger is in charge mode. As soon as the battery is fully charged the LED will turn
green.
Pay attention to the connecting sequence – first wall plug, than charger, than battery – other-
wise you will destroy the charger.
ATTENTION: Use the wall plug unit only in conjunction with the charger. Never attempt to
charge any other components or R/C radios with it.
Technical Specification:
Input current:
Output voltage:
Output current:
Charger
Polarity Assign-
ment Diagram
12.6V 8.4V 4.2V 0V
Charge jack for 2-cell
(7.4V) batteries
Charge jack for 3-cell
(11.1V) batteries
Specifications:
System:
Operating frequency:
Operating power:
Current supply:
required.
Wenn Sie Akkus verwenden, können Sie diese über die Ladebuchse am Sender laden.
Achtung: verwenden Sie dafür nur geeignete Ladegeräte. Verwenden Sie niemlas den Netzadapter
des beiliegenden Charger/ Balancer.
1000 mA DC
2 cells 7.4V charge jack : 8,4V 3 cells 11.1V charge jack: 12,6V
750 mA
Charge/ Charge
Status LED
Power LED
The R/C Transmitter
4 channel transmitter
72 Mhz
9.6 – 12 Volt
To operate the transmitter 8 AA batteries or 8 rechargeable NiMH batteries are
Input voltage:
Input Jack
Battery
Modulation:
Functions:
28
Schematics
Power Adapter/ Power
Charger
FM (PPM)
4 servos
15V – 18V
Source