1. This model helicopter is not a toy. Building and especially operating it requires special knowledge.
Mistakes and sloppiness during assembly, maintenance and operation may cause damage to
property and/or persons. Even as this helicopter comes preassembled, it is your responsibility to
check before every flight that all components are assembled properly and are undamaged. Make
yourself aware of any possible dangers as you are responsible for the correct operation of this
model helicopter.
2. Meticulously follow the assembly and operation instructions. Alterations on the helicopter or
disregard of the instructions will void any warranty.
3. Even a correctly assembled model may be dangerous. Never touch the moving main rotor blades
or any other open parts during operation, as you may hurt yourself.
4. In general it is your responsibility to use common sense, not to jeopardize safety and to prevent
damage to property and persons.
5. Only use original replacement parts and batteries of the same number of cells and capacity. Higher
number of battery cells will overload and destroy the motors, cause a fire hazard and generate
interference to the radio system.
6. Smaller than 2 cell batteries will result in dangerous flight situations or no flight at all. Always check
the battery after each charge, that all cells are o.k. If a cell is "puffed up", properly discard the
battery, as the battery is damaged beyond repair.
7. Always use fully charged batteries. As soon as you feel a power loss in flight, land immediately, as
low batteries can be responsible for malfunction and even a crash.
8. Before every flight inspect the main rotor blades, blade holders and blade screws. If these items
are damaged, they may fly away in any direction at high velocity and may cause damage to
property and hurt people.
9. Before every flight perform a range check. Have a second person observe the helicopter while
you walk away with the transmitter (antenna collapsed!) for about 25 yards. The control servos
and motors in the helicopter need to perform flawless when carefully giving control input on the
transmitter sticks. The servos have to move into the correct direction.
10. Before switching on the transmitter, make sure, that nobody nearby (at least 1 mile radius) is
using the same channel to operate a model.
11. Make sure that your take-off and landing area is free of obstacles and persons. Always keep a
watchful eye on your model during flight.
12. After landing immediately disconnect the flight battery and switch off your transmitter.
1. Da der Helikopter mit einem Fernsteuersender bedient wird, ist es sehr wichtig, sich zu vergewis-
sern, dass immer neue oder voll geladene Akkus verwendet warden. Achten Sie darauf, dass der
Akku nicht zu leer wird, sonst könnten Sie die Kontrolle über Ihren Helikopter verlieren.
2. Achten Sie darauf, dass keine der elektronischen Komponenten nass wird. Ansonsten könnte
Safety Instructions
Vorsichtsmaßnahmen
22