Acoustic Warning Signal; Cutting Sections; Service And Maintenance - Festool TSC 55 REB Guide D'utilisation

Acoustic warning signal

Acoustic warning signals sound and the machine
switches off in the following operating states:
Battery low or machine overloaded:
peep
Change the battery

Reduce the machine load

Sawing along the scribe mark
The cutting indicator [8-2] displays the cutting line
for 0° and 45° cuts (without guide rail).
8
8-1
8-2

Cutting sections

Place the machine with the front part of the saw ta-
ble on the workpiece, switch the machine on, press
WARNING
Risk of injury, electric shock
Always disconnect the battery pack from the

machine before any cleaning or maintenance!
All maintenance and repair work which requires

the motor housing to be opened, must only be
carried out by an authorised service workshop.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at:
www.festoolusa.com/service
it down to the preset cutting depth and push it for-
ward in the cutting direction.
– Always place the machine with the rear edge of
the saw table against a fixed stop.
– When working with the guide rail, place the ma-
chine against the kickback stop FS-RSP (acces-
sory) [10-4] clamped to the guide rail.
Procedure
Position the machine on the workpiece and

push up against a stop (kickback stop).
Switch on the machine.

Push down the machine slowly to the preset

cutting depth and then push forwards in the cut-
ting direction.
The markings [8-1] indicate the absolute front and
the absolute rear cutting points of the saw blade
(dia. 160 mm) when using the saw at maximum cut-
ting depth with the guide rail.
Gypsum and cement-bound fibreboards
Due to the high volume of dust, it is recommended
to use the cover ABSA-TS55 (accessories) which
can be mounted at the side at the protective cover
and a Festool mobile dust extractor.

Service and maintenance

EKAT
1
Observe the following instructions:
To ensure constant air circulation, always keep

the cooling openings in the housing unobstruct-
ed and air accessible.
Use an extractor on all openings of the power

tool to remove chips and splinters.
Keep the contacts on the machine, charger and

battery pack clean.
Sawing cut outs (plunge cuts)
In order to avoid kickbacks, the following in-
structions must be observed without fail
when plunge cutting:
Use only original Festool spare parts!
4
Order No. at:
5
3
www.festoolusa.com/service
2
17