Cleaning And Maintenance; Technical Specifications - SOLIS 8371 Mode D'emploi

CL E AN IN G A ND M A I N TEN ANC E
s
Clean the motor unit, the stirring tools and the blender shaft as well as the
●
attachments after every use to prevent leftover food from caking on the drive
shaft.
Make sure that the power plug is pulled before cleaning and that the attachment
●
has been removed from the blender shaft. Be careful to avoid injuring yourself
with the sharp blades.
Wipe the motor unit clean with a slightly moist, soft towel. Remove potential
●
GB
food leftovers on the power cord. Caution: Never hold the motor unit with the
power cord and the power plug under running water or submerge it in water
resp. clean it with liquids other than water.
Wash the stirring tools as well as the blender shaft and the blender jug in warm
●
water with a mild dishwashing liquid and a soft sponge. Best use a washing-up
brush to clean the sharp attachments to avoid injuring yourself with them. Dry
all parts carefully. If you have blended very salty food, you should wash the
attachments and the blender shaft right after using them, otherwise the salt
might affect the blades. Caution: Remember that the blades are very sharp and
do not injure yourself!
Tip: The stirring tools (egg whisks and dough hooks) can also be cleaned in the
●
dishwasher.
If you have processed foods that can cause discolouration like e.g. carrots, the
●
plastic parts might be discoloured. Wipe the discoloured areas with cooking oil
before cleaning them.
When not using the Solis Hand & Stick Mixer for prolonged periods of time, we
●
recommend greasing the drive shaft in the foot of the blender shaft with a few
drops of cooking oil so that it can rotate smoothly.
Caution: Do not use any aggressive or scouring detergents or steel sponges to
clean the appliance as these might damage the surface.
112
S T OR AG E
s
Check if the appliance has been disconnected from the power and is clean
●
and dry.
Store your Solis Hand & Stick Mixer in the storage box as shown on page 101.
●
The stirring tools, the blender shaft and the cord can be placed in the transpar-
ent lower part, the 4 attachments and the key can be placed in the part in the
middle. Place the motor unit on the upper storage base. Place the cord in the
transparent storage box and guide it through the channel on the side of the
layer with the compartments for the attachments resp. the upper storage box
towards the appliance. Like that, the appliance is stored with minimum space
requirements and ready for use.
Store the appliance in a dry, dark place; ideally in its original packaging. Do not
●
place anything on the appliance.
Always keep the appliance and the power cord out of the reach of children.
●
T E CHNI CAL SPEC I F IC ATI O NS
s
Model no. LW-2017G1, Type 8371
Product description Handheld mixer and blender
Voltage / frequency 220–240 V~ / 50/60 Hz
Output 400 watts
Dimensions approx. 20,0 @18,0@9,5 cm (W@H@D)
Weight approx. 1,0 kg
Technical changes reserved.
GB
113