Building In - Progress PAG 6430 E Notice D'utilisation

Building In

A = Auxiliary burner
SR = Semi-rapid burner
TC = Triple Crown burner
These hobs can be inserted in a built-in
kitchen unit whose depth is between 550
and 600 mm. The hobs dimensions are
shown in Fig. 5.
The cut out dimensions are shown in Fig. 6.
The edge of the cut out must have a
minimum distance from the rear wall of 55
mm.
If there are side walls, or sides of the
furniture unit near the hob, the cut out edges
must have a minimum distance of 100 mm.
Hanging forniture units or hoods must be
placed at 650 mm. minimum from the hob.
Fitting the hob to the worktop
Carry out the building in of the hob as
follows:
1. Place the seals supplied with the hob on
the front edge of the cut out. Then, place
them at 11 mm from the side edges and
at 10 mm from the rear edge, as shown
in the diagram, taking care that the seals
meet without overlapping.
2. Place the hob in the cut out, taking care
that it is centred.
3. Fix the hob with the relevant fixing
SR
SR
A
TC
Fig. 5
Dimensions are given in millimeters
15
progress
Fig. 6