Progress PAG 6430 E Notice D'utilisation page 14

14
progress
Remplacement of the voltage cable
The connection of the voltage cable to
the appliance's terminal block is of type "Y".
This means that its replacement requires the
specific equipment of a technician. In this
case, only cable type H05V2V2-F T90 must
be used. The cable section must be suitable
to the voltage and the working temperature.
The yellow/green earth wire must be
approximately 2 cm. longer than the phase
wires (Fig. 4-a).
To open the terminal block and reach the
terminals, proceed as follows:
insert the point of a screwdriver into the
visible protrunding part of the terminal
block;
exert a light pressure and lift (Fig. 4-b)
Fig. 4-a
Fig. 4-b
Neutral
Earth
(yellow/green))