Menu: Settings / Wcf Setup - BWT bestaqua 14 Notice De Montage Et D'utilisation

3.6.4 Menu: SETTINGS / WCF SETUP

Settings for recovery (WCF):
The main selection menu appears with "Start"
being activated.
START
St a r t
START
S e t t i n g s
Fig. 19: Main selection menu: "Start", "Settings"
The menu item
" WCF SETUP"
1. Menu level (selection menu
GENERAL
General
PRESSURE
Pressure of the permeate
CONDUCTIVITY
Conductivity value (μS/cm)
Permeate output WCF (ACTIVE)
WCF SETUP
Fig. 20: Menu Level 1: "Settings"
Press again the [ ] key to adjust the set points of
the WCF menu.
Please observe: It is only possible to enter
values within the programmed range of values.
Perform the settings of the "WCF SETUP" selection menu
in accordance with Fig. 21.
1x
is active.
" SETTINGS")
device settings
START
GENERAL
PRESSURE
CONDUCTIVITY
WCF SETUP
WCF
60 %
WCF set point
50 %
WCF set point
50 %
WCF set point
55 %
WCF set point
55 %
WCF set point
Fig. 21: Programming procedure: "WCF SETUP"
EN
START
47