Publicité
Les langues disponibles
Les langues disponibles
EN
3.6.3 Menu: SETTINGS / CONDUCTIVITY
Settings for permeate conductivity:
The main selection menu appears with "Start"
being activated.
START
St a r t
START
S e t t i n g s
Fig. 15: Main selection menu: "Start", "Settings"
The menu item
"
CONDUCTIVITY"
1. Menu level (selection menu "SETTINGS")
GENERAL
PRESSURE
CONDUCTIVITY
WCF SETUP
Fig. 16: Menu Level 1: "Settings"
Press the [ ] key again to set the limits for the alarm and
the activation/deactivation of the conductivity alarm.
2. Menu level (adjustable parameters)
CONDUCTIVITY LIMIT
CONDUCTIVITY ALARM
Fig. 17: Menu Level 2: "Settings/CONDUCTIVITY"
Note: In case you activate the "STOP" setting,
you have to deactivate and then activate the
device again.
Note: It is not possible to set the last digit "100"
at first. Please observe the right input order.
Perform the settings of the "CONDUCTIVITY"
selection menu in accordance with Fig. 18.
46
1x
is active.
device settings
General
Pressure of the permeate
Conductivity value (ACTIVE)
Permeate output, WCF menu
Conductivity limit value (ACTIVE)
Conductivity alarm
START
GENERAL
PRESSURE
CONDUCTIVITY
WCF SETUP
CONDUCTIVITY LIMIT
CONDUCTIVITY ALARM
090 μS
Conductivity limit
090 μS
Conductivity limit
050 μS
Conductivity limit
050 μS
Conductivity limit
050 μS
Conductivity limit
Fig. 18: Programming procedure: "CONDUCTIVITY"
START
CONDUCTIVITY LIMIT
CONDUCTIVITY ALARM
*
DISABLE
ALARM
Conductivity alarm
*
DISABLE
*
ALARM
Conductivity alarm
DISABLE
*
ALARM
Conductivity alarm
Publicité
Chapitres
