Charging - Dexter 20VSD2-35RC.1A Mode D'emploi

7. TECHNICAL DATA
Warning:
total value depending on the ways in which the tool is used. There is the need to identify safety
measures to protect the operator that are based on an estimation of exposure in the actual
conditions of use (taking account of all parts of the operating cycle such as the times when the
Note:
- that the declared vibration total value has been measured in accordance with a standard test
method and
- may be used for comparing one tool with another;
- that the declared vibration total value may also be used in a preliminary assessment of exposure.
Warning:
value depending on the ways in which the tool is used
- avoid vibration risk
suggestion:
1) wear glove during operation
2) limit operating time and shorten trigger time

8 . CHARGING

• Put the battery pack in the charger make sure it is place correctly(+ and -)(until click)
• Plug the charger into an appropriate outlet(230V), the red light on the charger will be on.
• Slide the battery into the charger, the light on the charger base will turn to red to indicate the
charging process has started.
• When charging is completed, the light on the charger base will turn to green. The pack is now
fully charged.
• Normally it will take 1 hour to fully charge the battery.
• Unplug the plug after charging
• Remove the battery pack by pressing release buttons on the pack and by pulling the battery
pack out.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may become hot. A hot battery pack may be
placed directly onto the charger port but charging will not begin until the battery temperature
cools to within acceptable temperature range. When a hot battery pack is placed on the charger,
the charger may indicate the pack is not ready to charge. Please refer to charger operator's
manual. When the battery pack cools the charger will automatically begin charging.
FR FR
ES ES
PT PT
IT IT
EL EL
PL PL
RU RU
UA KZ
KZ UA
RO RO
BR BR
EN
EN
249