Lenze ECSDS Série Instructions De Montage page 129

Bus cable length
)
Note!
The permissible cable lengths must be observed.
1. Check the compliance with the total cable length in Tab. 5−1.
The baud rate determines the total cable length.
CAN baud rate [kbit/s]
50
125
250
500
1000
Tab. 5−1 Total cable length
2. Check the compliance with the segment cable length in Tab. 5−2.
The segment cable length is determined by the cable cross−section used and the
number of nodes. Without a repeater, the segment cable length corresponds to
the total cable length.
Number of nodes
2
5
10
20
32
63
Tab. 5−2 Segment cable length
3. Compare the two values detected.
If the value detected from Tab. 5−2 is smaller than the total cable length to be
provided from Tab. 5−1 , repeaters must be used. Repeaters divide the total cable
length into segments.
,
Operating instructions for ECS axis module
Here you can find detailed information on how to use repeaters.
EDKCSDX064 DE/EN/FR 3.0
Max. bus length [m]
1500
630
290
120
25
Cable cross−section
2
0.25 mm 0.5 mm
240 m 430 m
230 m 420 m
230 m 410 m
210 m 390 m
200 m 360 m
170 m 310 m
l
Electrical installation
Wiring of system bus (CAN)
2 2
0.75 mm
650 m
640 m
620 m
580 m
550 m
470 m
5
2
1.0 mm
940 m
920 m
900 m
850 m
800 m
690 m
129