Publicité
ALIGNING THE WALL PLATE
D
Hole A
CAUTION: Wear gloves
CAUTION: Wear gloves
to avoid cutting fingers on
to avoid cutting fingers on
sharp edges.
sharp edges.
1. Draw a vertical line on the wall at the center of the 30''
wide space.
2. Use the mounting plate as the template for the rear
wall. Place the mounting plate on the wall, making
sure that the tabs are touching the bottom of the
cabinet or the level line drawn in Step C for cabinets
with front overhang. Line up the notch and centerline
on the bottom of the mounting plate to the centerline
on the wall.
3. While holding the mounting plate with one hand, draw
circles on the wall at holes A, B, C and D (see
illustration above/actual plate marked with arrows). Four
holes must be used for mounting.
INSTALLATION INSTRUCTIONS
Hole C
Area E
Draw a Vertical
Line on Wall
from Center of
Centerline
Top Cabinet
Notches
NOTE: Holes C and D are inside area E. If neither C nor
D is in a stud, find a stud somewhere in area E and draw
a fifth circle to line up with the stud. It is important to use
at least one wood screw mounted firmly in a stud to sup-
port the weight of the microwave. Set the mounting plate
aside.
4. Drill holes on the circles. If there is a stud, drill a 3/16''
hole for wood screws. For holes that don't line up with
a stud, drill a 5/8'' hole for toggle bolts.
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
10
Hole B
Hole D
Publicité
Chapitres
Dépannage
