Outside Back Exhaust; Preparing Rear Wall For Outside Back Exhaust; Remove Exhaust Adaptor; Attach Mounting Plate To Wall - Danby Designer DOM161KBLSDD Guide D'utilisation Et D'entretien

OUTSIDE BACK EXHAUST

B
(Horizontal Duct)
INSTALLATION OVERVIEW
B1. Prepare Rear Wall
B2. Remove Exhaust Adaptor
B3. Attach Mounting Plate to Wall
B4. Prepare Top Cabinet
B5. Adjust Blower
B6. Mount the Microwave Oven
IMPORTANT NOTES:
• Make sure the screws for the
blower motor and blower plate
are securely tightened when they
are reinstalled. This will help to
prevent excessive vibration.
• Make sure the motor wiring has
been properly routed and
secured, and that the wires are
not pinched.
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
You need to cut an opening in the rear wall for
B1
outside exhaust.
• Read the instructions on the REAR WALL TEMPLATE.
• Tape it to the rear wall, lining up with the holes
previously drilled for holes A and B in the wall plate.
• Cut the opening, following the instructions of the
REAR WALL TEMPLATE.
INSTALLATION INSTRUCTIONS

REMOVE EXHAUST ADAPTOR

This microwave oven is shipped assembled for top
B2
exhaust. You will need the exhaust adaptor for
installation in the rear wall opening. To remove the
exhaust adaptor from the microwave oven:
1 Remove tape securing damper.
Raise damper flap.
2
Blower Plate
Blower Plate
Remove and save the screw that holds the blower
4
plate to the microwave. Lift off the blower plate.
Blower Plate
15
Slip the damper
3
out of the track
on the blower
frame by pressing
and twisting
both ends.
Back of
Micowave
Back of
Microwave