Publicité
INSTALLATION INSTRUCTIONS
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
B3
Attach the plate to the wall using toggle bolts. At least one
wood screw must be used to attach the plate to a wall
stud.
Remove the toggle wings from the bolts.
1
2
Insert the bolts into the mounting plate through
the holes designated to go into drywall and reat-
tach the toggle wings to 3/4'' onto each bolt.
TO USE TOGGLE BOLTS
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
Place the mounting plate against the wall and
3
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the bot-
tom of the cabinet when pushed flush against the wall and
that the plate is properly centered under the cabinet.
CAUTION
Be careful to avoid pinching fingers between the back of the
mounting plate and the wall.
Tighten all bolts. Pull the plate away from the wall to
4
help tighten the bolts.
Bolt End
16
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
B4
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE
CAUTION
Wear safety goggles when drilling holes in the cabinet bottom.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
Remove and save screw that holds
B5 1
blower motor to microwave.
Blower Motor
Carefully pull out the blower unit. The wires
2
will extend far enough to allow you to adjust the
.
blower unit
BEFORE: Fan Blade
Openings Facing Up
End A
Back of
Microwave
Blower Motor
Screw
End B
Publicité
Chapitres
Dépannage
