INSTALLATION INSTRUCTIONS
SAFETY INSTRUCTIONS
This product requires a three-prong grounded outlet.
The installer must perform a ground continuity check on
the power outlet box before beginning the installation to
insure that the outlet box is properly grounded. If not prop-
erly grounded, or if the outlet box does not meet electrical
requirements noted (under ELECTRICAL REQUIRE-
MENTS), a qualified electrician should be employed to
correct any deficiencies.
For personal safety, remove house
fuse or open circuit breaker before
beginning installation to avoid
severe or fatal shock injury.
CAUTION
For personal safety, the mounting surface must be capable
of supporting the cabinet load, in addition to the added
weight of this 63–85 pound product, plus additional oven
loads of up to 50 pounds or a total weight of 113–135
pounds.
CAUTION
For personal safety, this product cannot be installed in cab-
inet arrangements such as an island or a peninsula. It must
be mounted to BOTH a top cabinet AND a wall.
NOTE: For easier installation and personal safety, it is
recommended that two people install this product.
IMPORTANT – PLEASE READ CAREFULLY. FOR
PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED TO AVOID SEVERE OR
FATAL SHOCK.
The power cord of this appliance
is equipped with a three-prong
(grounding) plug which mates
with a standard three-prong
(grounding) wall receptacle to
minimize the possibility of electric
shock hazard from this appliance.
Ensure
proper ground
exists before
use
CAUTION
You should have the wall receptacle and circuit
checked by a qualified electrician to make sure the
receptacle is properly grounded. Where a standard
two-prong wall receptacle is encountered, it is very
important to have it replacedwith a properly grounded
three-prong wall receptacle, installed by a qualified
electrician.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT,
DEFORM OR REMOVE ANY OF THE PRONGS
FROM THE POWER CORD. DO NOT USE WITH AN
EXTENSION CORD.
ELECTRICAL REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz, 15 amps and
1.58 kilowatts. This product must be connected to a sup-
ply circuit of the proper voltage and frequency. Wire size
must conform to the requirements of the National
Electrical Code or the prevailing local code for this kilo-
watt rating. The power supply cord and plug should be
brought to a separate 15- to 20- ampere branch circuit
single grounded outlet. The outlet box should be located
in the cabinet above the microwave oven. The outlet box
and supply circuit should be installed by a qualified electri-
cian and conform to the National Electrical Code or the
prevailing local code.
3