Maytag W11384459B Instructions D'utilisation page 22

Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.70 gpm (2.65 Lpm). Pressure = 60 psig (413.7 kPa).
Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters) with PID, 100 gallons (379 liters) without PID.
The compounds certified under NSF 401 have been deemed as "emerging compounds/incidental contaminants." Emerging compounds/incidental contaminants
compounds that have been detected in drinking water supplies at trace levels. While occurring at only trace levels, these compounds can affect the public acceptance/
perception of drinking water quality.
It is essential that operational, maintenance, and filter replacement
■
requirements be carried out for the product to perform as advertised.
Property damage can occur if all instructions are not followed.
The disposable cartridge must be changed at least every 6 months.
■
Use replacement filter UKF8001, Part # EDR4RXD1/EDR4RXD1B. 2018
■
suggested retail price of $49.99 U.S.A./$49.95 Canada. Prices are subject to
change without notice.
The filter monitor system measures the amount of water that passes through
■
the filter and alerts you when it is time to replace the filter. To learn how to
check the water filter status, see "Using the Controls" or "Water Filtration
System" in the User Instructions or User Guide.
After changing the water filter, flush the water system. See "Water and Ice
■
Dispensers" or "Water Dispenser" in the User Instructions or User Guide.
These contaminants are not necessarily in your water supply. While testing
■
was performed under standard laboratory conditions, actual performance
may vary.
*Class I particle size: >0.5 to <1 um
Based on the use of Cryptosporidium parvum oocysts
†
†† Fibers greater than 10 um in length
NSF is a registered trademark of NSF International.
®
22
The product is for cold water use only.
■
The water system must be installed in compliance with state and local laws
■
and regulations.
Do not use with water that is micro biologically unsafe or of unknown quality
■
without adequate disinfection before or after the system. Systems certified
for cyst reduction may be used on disinfected waters that may contain
filterable cysts.
EPA Est. No. 69625-CT-001.
Refer to the "Warranty" section for the Manufacturer's limited warranty, name
■
and telephone number
Application Guidelines/Water Supply Parameters
Water Supply
Water Pressure
Water Temperature
Service Flow Rate
Your water filtration system will withstand up to 120 pounds per square inch
■
(psi) water pressure. If your water supply is higher than 80 psi, install a
pressure reducing valve before installing the water filtration system.
Potable City or Well
30 - 120 psi (207 - 827 kPa)
33° - 100°F (0.6° - 37.8° C)
0.70 GPM (2.65 L/min.) @ 60 psi.
(413.7 kPa)