Faults - FUST Novamatic EK 716.6-IB Mode D'emploi

Condensation can form on the glass
I
shelves if products are stored which emit
water vapour.
As the electronic control in the refrigera-
I
tor only defrosts about once per day, the
ice formation on the rear wall in the re-
frigerator itself can be more marked
than is usual in previous refrigerators.
Be careful that products do not come
I
into contact with the rear wall of the ref-
rigerator so that they do not freeze to it
and that, during defrosting, water does
not get diverted into the refrigerator.
Take the temperature only in containers
I
with liquids; never measure the air tem-
perature.
When filling be careful that:
I
– Oil and fats do not come into contact
with the polymer parts and the door
seals.
– The coldest locations in the refrigera-
tor for any setting of the temperature
controller are at the back wall and
above the lowest shelf. Sensitive pro-
ducts should therefore be put on
the lowest shelf.
– To avoid possible warming of the pro-
ducts, keep them clear of the lamp.
this will also guarantee sufficient ven-
tilation for the lamp.
Example of how to use:
I
– Freeze and store foodstuffs and make
ice in the freezer compartment.
– On the shelves from top to bottom:
baked products, ready-made meals,
dairy products, meat and sausages.
– In the suspended trays from top to
bottom: butter and cheese, tubes,
small cans and eggs, large bottles.
– In the vegetable compartment:
vegetables, fruit and salad.
38
(
Changing the light bulb
A defective bulb must be replaced at once.
Switch off the power supply. Remove the
I
the side (fig. ().
plug or trip the circuit breakers.
Pull off the lamp protection cover from
I
Bulbs can be obtained from your local
I
service agent or an electrical supplier
(230V/15W/E14).

Faults

The refrigerator was checked for correct
function before delivery. In the event of
operating faults, contact your local service
agent, detailing type of refrigerator and
the fault.
Faults can also be due to the tripping of
electrical circuit breakers. The fault is easy
to rectify by resetting the circuit breaker in
question.