Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
– Set the temperature controller to
position «0».
– Leave the doors open.
Defrosting can be accelerated significantly
if you place a bowl of hot water in the free-
zer compartment.
Attention: do not use sharp implements to
remove ice or anything hard frozen. Do not
use an electrical heater or an open flame
for defrosting.
– After defrosting clean the interior and
dry it thoroughly.
– Move the temperature back to Position
Normal between the two temperature
symbols. Replace the frozen products.
Refrigerator
The height of the unbreakable secured
glass shelves can be adjusted individually.
By pressing both holders sideways at the
same time, the glass shelve can be swung
upwards and removed. To fixture the glass
shelf: push the glass shelf back into the
holder and, at the front, press it down into
the holder.
Cleaning
The refrigerator is to be kept clean for the
hygienic storage of foodstuffs. It should be
washed out from time to time with a mild
soapy solution and then dried. An occasio-
nal wiping of the refrigerator with a vine-
gar solution suppresses odours and is re-
commended. Keeping the door seals clean
stops them from sticking and thus avoids
them being damaged. No scouring clea-
ners or scratching cloths are to be used.
Clean the door seals with a soft brush. If
the refrigerator has not been used for
some time, set the –temperature controller
to position «0». Empty the refrigerator,
defrost it, clean, and then leave the refrige-
rator as well as the freezer compartment
open.
– Be careful that no cleaning water can get
into the controller housing (danger of
short circuit).
– Be careful that as little cleaning water as
possible goes though the drainage chan-
nel into the collection dish.
– Before being put back in use, the unit
and the seals of the refrigerator and the
freezer must all be completely dry.
Tips
The following points should be noted when
using the new refrigerator:
The unit should not be installed near
I
heaters, radiators, or smoke ventilators,
and should be protected from direct
sunshine.
A unit which has just been put into use
I
needs approx. 15 hours (with products)
until it has reached its normal operating
temperatures.
Keep the refrigerator doors open for as
I
short a time as possible. If the doors are
open for longer than 2 minutes then the
refrigerator lamp starts to flash. Make
sure after closing that the doors are fully
sealed. The self-closing hinges assist this.
The cooling time for beverages and
I
other products can take up to 6 hours
from room temperature down to the re-
frigerator temperature. The warmer they
are when put in, the longer this time will
be.
Re-setting the temperature control has
I
no effect on the cooling rate, only on
the temperature reached.
Allow warm or really hot products cool
I
down outside the refrigerator.
37
Publicité
Chapitres
Table des Matières
