Mechanical Adjustments; Setting Up The Forearm Support; Setting Up The Driving Mechanism - Kinetec Maestra Manuel D'utilisation

13. Mechanical adjustments

13.1.

Setting up the forearm support

The forearm support should be on the RIGHT side of the machine for the LEFT
Hand, and on the LEFT side for the RIGHT Hand.
For prono-supination or thumb opposition, place the forearm support IN
FRONT of the motor axis (see page 15 or 17).
The forearm support is mounted on a telescopic rod (1).
There are also two notched joints (2) and (3),
which allow the wrist to be positioned:
- in extension,
- in ZERO position,
- or in flexion.
Extension
2
1
The joints also permit the forearm support to be tilted up or down.
However, if this is done, the angle of tilt should be taken into
account when setting the range of motion on the display (see
page 6).
13.2.

Setting up the driving mechanism

The driving mechanism should be attached to the motor axis.
In order to facilitate its setting up, use the intrinsic + movement and stop the unit at 0°.
LEFT hand
Note
Make sure that when the driving mechanism is inserted on
the motor axis, the cable (4) is ABOVE the groove of the
cam (5).
The driving mechanism should then be locked in place by
tightening the screw (6) with the Allen key included in the
accessory case.
Kinetec Maestra™
Zero Position
3
EN
Position for the left hand
Flexion
RIGHT hand
6
4
5
13 / 23