Using Programs; Reading The Values Of A Program: E.g. Speed - Kinetec Maestra Manuel D'utilisation

12.8.2.

Using Programs

The device Kinetec Maestra™ allows you to store up to 16 programs (numbered 1 to 16), including the type
of movement, ROM, speed, load, pauses and timer.
The original parameter values of the program are empty. These values can be modified and saved at any
time (see 'To enter a program', page 9)
Beginning
To stop the unit
To access program mode
To change the program if necessary
To exit and confirm the selected program
To exit without confirming the selected
program
To start the unit
Warning: Always check the motion parameters displayed on the hand control before starting the device.
12.8.3.

Reading the values of a program: e.g. SPEED

Beginning
To stop the unit
To access program mode
To change the program if necessary
To read the speed value
After 15 seconds or after pressing on another
key
To exit and confirm the selected program
To start the unit
Comments:
• The values shown in the 'Display' column are examples. They actually depend on the stored programs.
• The current movement parameters can be changed while using that program but no data will be stored in
the original program. See Program Mode (page 9) to modify programs.
Comments
:
• When a program has been deleted, the display shows
Kinetec Maestra™
Keys to
Display
press
PRONO/SUPINATION
-10 STOP
WRIST
-30 PRG
THUMB OPPOSITION
0 PRG
or
THUMB OPPOSITION
0 STOP
PRONO/SUPINATION
-10 STOP
THUMB OPPOSITION
0 RUN
Keys to
Display
press
WRIST
25 STOP 20 90
PRONO/SUPINATION
-10 PRG
THUMB OPPOSITION
or 0 PRG
THUMB OPPOSITION
SPEED: 2
WRIST
25 STOP 20 90
THUMB OPPOSITION
0 STOP 20 50
THUMB OPPOSITION
0 RUN
EN
Check that the hand control is not
5 10
locked (See page 6).
EXT/FLX
The program number blinks.
no.2 30
The new program number blinks.
no.5 30
The current parameters are those
10 30
recorded in program 5.
Back to the starting parameters.
5 10
The angle display changes with the
20 30
current movement.
EXT/FLX
Check that the hand control is not
locked (See page 6).
The program number blinks.
no.4 10
The new program number blinks.
no.3 50
Displays the speed value.
EXT/FLX
The current parameters are those
recorded in program 3.
The angle display changes with the
20 50
current movement.
Program
EMPTY
Remarks
Remarks
11
10 / 23