Truvox International Orbis ECO 200 Manuel D'utilisation page 3

2. The machine must be unpacked and assembled in
accordance with
connecting to the electrical supply.
3. Operators must be fully trained in the use of the
machine in accordance with these instructions,
able to perform regular user maintenance and the
correct selection of accessories.
4. Operators should
manoeuvre, transport and operate the machines.
5. Operators should be able to recognise unusual
operation of the machine and report any problems.
6. Only genuine accessories and spare parts
provided with the machine or those approved by
the manufacturer should be used.
other accessories may impair the safety of the
machine. All repairs must be performed by a
qualified service agent.
7. Do not use without filters in place.
8. Do not modify the machine from its original design.
9. Only use the machine on firm level surfaces. DO
NOT use on a gradient or more than 2% slopes.
10. DO NOT use on rough uneven surfaces e.g.
industrial or coarse concrete surfaces.
11. DO NOT use outdoors e.g. on patios, decks or
rough surface.
12. DO NOT use volatile or combustible solvents (e.g.
diesel/petrol/IPA/trichloromethane)
corrosive, toxic or highly irritant substances to
wash floors, even if diluted.
In the event of accidental contact with any such
substances (e.g.
decontamination procedures in force at the user
site. The drive board may be re-used after
thorough washing, but the pad should be disposed
of as contaminated waste, in accordance with
local procedures.
If in any doubt about the condition of the machine,
contact Truvox or the dealer/agent who supplied
the machine.
13. This machine is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless
supervision or instruction concerning use of the
machine by a person responsible for their safety.
14. Keep children and unauthorised persons away
from the machine when in use. Do not use as a
toy.
15. The machine must be kept clean and in good
condition with regular inspections of the power
cord lead and plug for signs of any damage. If any
parts are damaged they shall only be replaced by
an approved part by the manufacturer, its service
agent or a similar qualified person in order to avoid
a hazard.
16. CAUTION - This machine is for dry indoor use
only and should not be used or stored outdoors in
wet conditions.
17. DO NOT use where hazardous dust is present.
18. DO NOT use in an explosive atmosphere.
19. DO NOT pick up or use near flammable or
combustible fluids, hazardous dusts or vapours.
20. Do not use to pick up moisture or any liquids
3
these instructions before
be physically capable
The use of
nor
due to spills) follow
they have been
ELECTRICAL HAZARD
21. CAUTION - If it is suspected that there is
hazardous dust or flammable/corrosive material
stop cleaning the area immediately and consult
your superior.
22. DO NOT use to clean up any burning or lighted
materials such as cigarettes, matches, ashes or
other combustible objects.
to 23. Take care when using a machine near the top of
stairs to avoid overbalancing.
24. DO NOT put any object into openings. DO NOT
use with any opening blocked; keep free of dust,
debris and anything that may reduce airflow.
25. DO NOT cover the machine when in use.
26. Keep hair, loose clothing, hands, feet and all other
parts of the body away from openings and moving
parts.
27. DO NOT use if it has been damaged, left outdoors
or dropped in water.
28. Do not operate the machine with a damaged
supply lead or plug, or after the machine
malfunctions or is damaged in any way. Contact
an authorised Service Agent for repair or
adjustment.
29. Only replace the supply cord with the type
specified in the instruction manual.
30. This machine should always be connected to a
any fully earthed power supply of the right voltage and
frequency.
31. DO NOT leave machine running unattended.
32. Do not leave the machine connected to the
the electricity supply when not in use, always remove
the plug from the socket-outlet.
33. Switch off the machine before removing the plug.
34. When unplugging, pull the plug, not the supply
cord.
35. The machine shall be disconnected from its power
source when not in use and before commencing
cleaning of the machine or maintenance and when
replacing parts or accessories, by removing the
plug from the socket-outlet.
36. DO NOT pull or carry by the supply cord. DO NOT
use cord as a handle, close door on cord or pull
given cord around sharp edges or corners.
37. WARNING: Keep the supply cord clear of moving
parts.
38. DO NOT kink or twist the supply cord and keep
cord away from heated surfaces.
39. DO NOT operate switches or touch the mains plug
with wet hands as this may cause electric shock.
40. The power supply cord plus any extension leads
should not exceed 30 metres in total. The cross
section of an extension cable wiring must be at
least 2.5mm².
Cleaning Agents
1. When using cleaning and care agents, the
manufacturer's danger warnings must be followed
and protective goggles and clothing must be worn.
2. Only use low- foaming, non- combustible cleaning
agents which do not contain generally health-
hazardous substances.
06-16