Operation - Laserworld Club Série Mode D'emploi

Manual: Club Series MKII

8. Operation

1. Connect the power cable to the device and then to the mains
2. Insert key and turn it ‚ON'
3. Press „ON" to switch the device on
4. The Interlock adapter is already attached. There is no need to change anything. The
show laser doesn't work if the Interlock adapter isn't connected to the device.
5. Modes:
Your device runs in auto mode (random playback of the preset patterns):
Your device runs in music mode (random playback of the preset patterns according to
music, sound or any other noises):
Control the music sensitivity by the trim pot at the rear side of the device. The Micropho-
ne LED (at the front side of the device) is ashing when the device is triggered.
Your device runs in DMX mode if '10' is switched o :
The DMX mode only works when a DMX controller is connected to the laser.
Use the switches 1 - 9 to set the DMX address of the laser. Each switch represents a num-
ber. To de ne a number use the preceding number and multiply it by 2:
Switch 1
Number 1
The laser uses 11 DMX channels, so make sure that the next device uses an address that
doesn't overlap with this range.
page 8 / 33
2 3 4
2 4 8
5 6 7
16 32 64
8 9 10
128 256 Mode Switch