Working On The Device; Service Notes - Laserworld Club Série Mode D'emploi

Manual: Club Series MKII
10. If the device has been exposed to great
temperature changes, do not switch it
on immediately. Condensation (or any
moisture/water formed) may damage
device.
11. Never use dimmer, RC or other elect-
ronically switched sockets. Whenever
possible, do not use the laser projector
together with large appliances (espe-
cially fog machines) on the same mains!

4. Working on the device

1. This product has no user serviceable parts inside and should
only be maintained and serviced by a quali ed engineer.
2. Be sure that the mains plug is not connected to the power
supply while installing.
3. Take o all re ecting things like rings, watches etc. befo-
re starting to work with or at the projector.
4. Only use non-re ecting tools to work on device.
5. Wear protective clothing (like goggles, gloves etc.) according to laser power and wave-
length of the laser.

5. Service notes

Moisture and heat can reduce lifetime of
the laser system dramatically and expires
any warranty claim.
Quick on/o switching of this device will
reduce durability of the laser diode dra-
matically.
Avoid sharp knocks and shocks to this
device and ensure su cient protection
during transportation. Look after your La-
serworld product.
To increase durability of your laser,
protect device against overheating:
page 5 / 33
12. Ensure su cient ventilation and do not
place the device on any warm or heat ra-
diating surface. Especially the ventilati-
on openings must not be covered!
13. Ensure that device does not get over-
heated. Make sure that the device is not
exposed to spotlights (especially moving
heads). Heat of spotlights could overheat
laser in a little while and leads to a degra-
dation of performance.
14. This unit is intended for indoor use only.
Always ensure su cient ventilation.
Do not face spotlights (especially mo-
ving heads) to the device.
Check temperature after approx. 30
minutes with each new installation. If
necessary install the projector at a place
with di erent temperature.
Keep the device dry. Protect it from
moisture, rain and damp.
Switch o device when it is not needed.
Diodes are switched on and can wear out
even if there is no visible laser output.