Pet Fountain Reassembly - Petsafe Drinkwell Grand Chien DOGC-AU-17 Manuel D'utilisation

Pet Fountain Reassembly

1. Turn the Bowl upside down. Reattach the Pump by pushing the threads of the Pump
through the hole in the Bowl. The Pump goes in at a right angle to the Bowl (Fig. 9). If
you cannot turn the Pump into its resting position, the Pump is not pushed into the hole
as far as it will go.
2. After turning the Pump a quarter turn, it should now be even with the bottom of the
Bowl (Fig. 10). Turn the Bowl back over.
3. Place the Intake Plate over the exposed portion of the Pump found in the Bowl (Fig. 11).
4. Join the Flow Control Knob and Intake Plate together by placing the tabs of the Flow
Control Knob into the groove of the Intake Plate (Fig. 12-13).
5. Hold these parts in place with one hand while attaching the
Housing with the other hand (Fig.
14). Attach the Housing by sliding
the cutout in the wall of the Housing
down in between the Flow Control
Knob and Intake Plate (Fig. 15). The
Housing will click into place, when
the side tabs are inserted in the Bowl.
6. Place the Pet Fountain in desired
location. Important: To protect
Fig. 9
Fig. 11
Groove
Tabs
www.petsafe.net
Intake
Plate
Fig. 12
Fig. 14
Fig. 10
Fig. 13
Fig. 15
11