Fountain Reassembly - Petsafe Drinkwell Big-Dog Pet Fountain Manuel D'utilisation

FOUNTAIN REASSEMBLY

1) Turn the bowl upside down. Reattach the motor by pushing the
threads of the motor through the hole in the bowl. The motor
goes in at a right angle to the bowl (Fig. 8a). If you cannot turn
the motor into its resting position (Fig. 8b), the motor is not
pushed into the hole as far as it will go.
Fig. 8a
After turning the motor a quarter turn, it should now be even
2)
with the bottom of the bowl (Fig. 8b). Turn the bowl back over.
Place the stator over the exposed portion of the motor found in
3)
the bowl. (See Fig. 9)
Fig. 9
Join the flow control knob and stator together by placing the
4)
tabs of the knob into the groove of the stator. (See Fig. 10)
Fig. 10
Hold these parts in place with one hand while attaching the
5)
housing with the other hand. (See Fig. 11 - Next Page) Attach
the housing by sliding the cutout in the wall of the housing
down in between the control knob and stator. The housing will
click into place, when the side tabs are inserted in the bowl.
(See Fig. 12 - Next Page)
Fig. 8b
TABS
www.petsafe.net
STATOR
GROOVE
9